Remix each of the two components (part A and B) every time before using.1. Mixing the two componentsThe components A and B are mixed by weight in the above indicated ratio. The mixing can be carried out either by hand or by using a low-speed electric or pneumatic mixer to minimise the introduction of air and to avoid any temperature increase.It is also possible to use a special mixing and dispensing machine for the two silicone components. Further information is available upon request.2. Degassing The mixture should be degassed preferably at 30 to 50 mbar to eliminate any entrapped air. If a dispensing machine is used, the two components are degassed separately prior to mixing.The silicone mixture expands to times of its initial volume and bubbles rise to the surface. Wait a few minutes to complete the degassing and then flash the vacuum. The silicone is ready for pouring, either by gravity or under low pressure.Note: Flashing the vacuum once or twice accelerates the degassing. It is recommended to use a container with a high diameter / height ratio.3. PolymerisationThe system polymerises at . The curing may be slowed down at lower temperature or accelerated by heat.Contact with certain materials can inhibit the crosslinking. See list below:
SILBIONE RTV 4528 A&B is a two component silicone elastomer which cures at room temperature by a polyaddition reaction. The polymerisation can be accelerated by heat.The silicone material is delivered as two low viscous liquid components, which once mixed and cured, transform into an elastic and resistant material. Polymerisation occurs without formation of heat.