Product

 

 

The aerosol should be applied on perfectly clean, grease-free surfaces so that the film spreads well.
To obtain an even coating, hold the can between 25 or 30 cm from the surface to be treated and spray with a smooth back and forth motion. This produces a thin, even, anti-stick film.
Avoid any surplus, which might be detrimental to the moulded or injected material.
Frequency of spraying of the BLUESIL AEROSOL SIL JET will be determined by practice, depending on the complexity of moulds and the type of product moulded


This aerosol uses a propane/butane mixture as propellant gas, together with inflammable liquids as solvents.
It is essential to work in a well ventilated room during and after use of the product.
Smoking is prohibited during and after the operation.
Do not spray near a flame, an incandescent body or surfaces which could generate sparks (i.e. presence of electrostatic charges).
Do not pierce or burn after use.
THE BLUESIL AEROSOL SIL-JET SHOULD NOT BE EXPOSED TO SUNLIGHT OR TO A TEMPERATURE EXCEEDING .

从生产日期开始产品BLUESIL AEROSOL SIL JET保质 0个月请查看安全数据表

BLUESIL AEROSOL SIL JET

BLUESIL AEROSOL SIL JET is a mould-release spray, containing a polydimethylsiloxane oil.
This product is CFC free.

润滑;不粘;离型;顺滑

聚二甲基硅氧烷

硅油

  • Easy to use.
  • Effective at low doses.
  • Good surface finish of moulded articles.
  • Far fewer rejects.

 

Temporary mould-release agent (1 or 2 cycles) for plastics and non-silicone rubbers.
Release agent and lubricant for a wide temperature range. It is recommended for associations of metal with elastomers and plastics.
Rubber to metal release agent that stays effective at very low temperatures.

亚太区;欧洲中东非洲;中南美;北美

 Characteristics_A

 

 

粘度350Monocompmm2/s

 Characteristics_B

 

 

 

 

 Table_Characteristics_A_And_B

 

 

 

 

 

 

 

 

 

 

 NeedAnExpert

 

 

 CS

 

 

 SS

 

 

 PressRelease

 

 

 

 

 Brochures

 

 

 TDS