Product

 

 

Silbione® M&P Primer is designed to be applied to a clean dry surface.  The M&P Primer is applied by brushing, dipping, wiping, or spraying.  A thin film will give the best results.  Thickness can be controlled by thinning the solution in aromatic or aliphatic organic solvents. The primed substrate must be exposed to atmospheric moisture immediately after application for 30-60 minutes to induce evaporation of the solvent and to cure the primer.  Prolonged exposure greater than 2 hours will reduce effectiveness.  A minimum of 30% atmospheric relative humidity is recommended for full cure, and therefore, maximum adhesion to substrate. Air exposure of the primer should occur immediately after application to the clean surface to be primed.  If immediate exposure to air containing at least 30% relative humidity does not occur, the resulting primed film may result in poor adhesion to both the substrate and to subsequent silicone material added to the primed substrate.

SILBIONE M&P PRIMER may be stored for up to 12 months from its date of manufacturing.Please consult the Safety Data Sheet of this product.

SILBIONE M&P PRIMER

Silbione® M&P Primer is a 10% active adhesion promoter dispersed in xylene that improves adhesion of silicone elastomers to some substrates such as metals, ceramics and plastics.

Primer

Primer

Fluid

​• Low viscosity for easy handling

• Applicable by spraying, dipping, or brushing

• Air dries - no heat required

• Improves silicone elastomer bonds to most substrates

This product is well-suited for coupling Elkem Silicone’s Liquid Silicone Rubbers, High Consistency Rubbers, and Adhesives to metals, fabrics, plastics, ceramics, and other substrates.

Asia Pacific;Europe Middle East Africa;Central and South America;North America

 Characteristics_A

 

 

 Characteristics_B

 

 

 

 

 Table_Characteristics_A_And_B

 

 

 

 

 

 

 

 

 

 

 NeedAnExpert

 

 

 

 

 CS

 

 

 SS

 

 

 Certif

 

 

 

 

 Brochures

 

 

 TDS