The joint faces to be bonded must be clean, dry and free from dust, oil, grease, old sealant and any traces of contaminant which may affect adhesion. Surfaces should be degreased with solvent soaked cloth and then wiped with a clean cloth. To remove dust, use oil-free compressed air.
Although BLUESIL SLT 3B will bond well to most clean and dry surfaces, it is recommended that a primer be used on certain substrates in order to ensure a strong and uniform bond :
· Cast, extruded or anodised aluminium : BLUESIL PRIM 10073
· Steels, ferrous metals, painted and most rigid plastics : BLUESIL PRIM 10073
· Concrete, wood : BLUESIL PRIM 12076
In the case of particularly porous materials, apply a second layer after drying.
The movement capability of sealants as well as local regulations must be considered. Jointwidth should be twice the depth.
For good performance it is essential that the sealant is only bonded to the two facing sides of the joint. To achieve this install a backup material (closed cell polyethylene or open cell polyurethane foam). Apply the sealant in a continuous operation making sure all air pockets or voids are eliminated. Tool the sealant with light pressure to spread the material against the joint surfaces.
This operation should be made with a dry spatula before skin formation occurs.
Excess uncured sealant should be wiped and cleaned with a commercial solvent, cured sealant can only be removed by scraping (i.e. with a razor blade), or with a special silicone remover product.
|STORAGE -5°C ||Avoid discharge into drains, water courses or onto the ground. Store in tightly closed original container. Store in a cool, dry place with adequate ventilation. Keep away from incompatible materials, open flames, and high temperatures. Avoid contact with oxidizing agents. Vulcanises at room temperature on contact with moisture in the air. For further information, refer to Section 10: "Stability and Reactivity". Suitable containers: Steel drums coated with epoxy-resin.||Please consult the Safety Data Sheet of this product.||RoHS|
BLUESIL SLT 3B BLACK
BLUESIL SLT 3B is a one-component silicone sealant which when exposed to atmospheric humidity, cures rapidly to form a permanently flexible and extremely durable weather tight seal. The cured sealant will accommodate joint movement of maximal amplitude of 25 % throughout a wide temperature range resistance to severe weathering is excellent.
1 Part RTV Acetoxy
BLUESIL SLT 3B bonds strongly to clean uncoated glass, ceramics and glazed or painted surfaces without the need to prime. For most other substrates it is recommended that a primer be used, a range of high performance primers is available which will ensure optimal bonding to most commonly encountered substrates.
After cure, BLUESIL SLT 3B will be resistant to many acids and bases diluted and salt spray and will tolerate short exposure to most industrial solvents and hydrocarbon based products, in the latter case some reversible swelling and softening will occur.
The exceptional translucent quality of BLUESIL SLT 3B is such that it is ideally suited for use where the sealant is visually prominent, examples being, display cases and shop windows.
|BLUESIL SLT 3B is a high modulus sealant and should be selected for use on applications where joint loads are high and where relative movement between substrates is to be minimised. When used on external joints a weathertight seal or high integrity will result.|
· All classical glazing joints
· Door and window frames
· Cladding and curtain wall construction
· Shop windows, display cases, panels and signs
· Portable buildings, caravans and containers
· Conservatories and greenhouses
· Heating, ventilation and air conditioning (HVAC) ducting
· Construction joints
· Swimming pools
· Marine hardware
Asia Pacific;Europe Middle East Africa;Central and South America;North America
|For information about Storage and Shelf Life for this product, please download the Technical Data Sheet.|